Base Knowledge- 

• Model number: MF985
• Entry-level Device 
• Made best for 1-2 People 
• 90-day warranty 
• Type C charger 
• Can handle up to 10 devices, recommend 5   

The Velocity 2 is best for travel, it is not meant to be plugged in constantly. The Battery will swell if the Velocity 2 is left plugged into the wall charger at all times. Velocity 2 has a few common issues with easy troubleshooting steps. Customers do not believe there is a SIM card installed. However, the SIM card is pre-installed into the device for customer convenience.  

Steps to take to find the Sim card: At the bottom-right side of the device beside the charging port, you should see a slot with a little hole next to it. You will need a safety/bobby pin to press the release button inside that little hole. Once you do that, a tray will pop out. That tray holds your SIM card (and also an optional micro-SD card, if you would like). 

How to factory reset:

1. From the home screen, tap Settings.
2. Scroll to, then tap Factory reset.
3. Tap Reset Device.
4. Tap OK.

If you cannot reset the device via the Settings, open the SIM card cover, and use a paperclip to press the reset button for 10 seconds.

Velocity 2 APN Settings:  

Connect your laptop or phone to your Velocity 2. 

Once connected pull up a web browser and type http://192.168.1.1 or http://attwifimanager 

Once you have that site up your will type in "attadmin" as the password to log in to the site. (If this does not work please perform a factory reset on the device.)  

Click Settings>Click Network 

Click APN 

Click the Radial button Beside "Manual" > Place your cursor in the Profile Name and type in OTR Mobile > Then you will type the APN corresponding with the plan into the APN field. (Please See the guide below for APN settings below the last image

APNS/Settings: (PLEASE NOTE THAT THESE ARE CASE SENSITIVE)

• APN: hotspot.accessmylan.net 
• PDP TYPE: IPV4
• Authentication: PAP                                                                                                                                                                                                                                                                                                                                                                                               
• USER: "data"
• Password: "data"                                                                
• Then proceed to click the "Set Default" button.

Afterward please restart the device by powering it off for a moment then back on and test it.