Knowledge Base:  Model MR1100  Will work with AC power and battery power  Greenlight means ready to connect One year warranty (On NEW devices) Can handle up to 20 devices  Runs two wifi Network: 2.4GHZ and 5GHZ  Made for home and travel.  The NightHawk has a wide range and ability to handle many devices. The device can run with the battery to be mobile, or able to remove the battery and leave plugged into the wall charger to run non stop.

 How to factory reset: Remove the back of the Nighthawk, follow the arrows. Push a small object into the hole below the battery and hold for 10-15 seconds. (Picture on the left show) The Nighthawk will completely power off, then restart itself. Once it powers on, you can connect and test. Setting the Apn: On a device connected to your hotspot, open a browser and enter http://attwifimanager or http://192.

How to factory reset: Remove the back of the Nighthawk, follow the arrows. Push a small object into the hole below the battery and hold for 10-15 seconds. (Picture on the left show) The Nighthawk will completely power off, then restart itself. Once it powers on, you can connect and test. Setting the Apn: On a device connected to your hotspot, open a browser and enter http://attwifimanager or http://192.

Please follow the step by step process as follows to unlock your device: Step 1:Insert your new SIM card. Step 2:Power on, and connect to your device. Step 3:For Velocity 2 and Nighthawk: Go tohttp://attwifimanager & set up your device.  For Homebase: Go tohttp://att.wirelessinternet & set up your device. Note: Some devices will have an “enter unlock code” message pop up as soon as you log in. You can enter the code there.